Tying Concrete Walls Together

Thank you for all your support https www paypal me mountainhomestead essential.
Tying concrete walls together. If the joint is taller than wide place the holes vertically. Then pack the cores with mortar around the angle and seal the joint between the new blocks and the old wall with a good elastomeric caulk. Fill the hole with epoxy slowly. Drill 5 8 inch diameter holes six inches deep into the old concrete.
Use rebar about 1 3 in 0 85 cm in diameter to reinforce the concrete. Make these holes 12 inches on center horizontally or vertically depending upon the predominant orientation of the joint. Snap tie concrete forms are a simple and easy system for foundation walls. Load your concrete epoxy adhesive into the epoxy gun according to the instructions included with the gun.
If the joint is wider than it is tall place the holes horizontally. This will provide lateral support to the wall but will allow some minor vertical movement without cracking. Pull the tip of the gun out of the hole as it fills. Lay the rebar in a grid with the bars spaced about 12 in 30 cm apart.
This tie is used mostly on floor slabs. Provide a bond breaker on each leg of the angle and break out the end webs of the new blocks. Insert the tip of the epoxy gun into the hole as far as you can. If you need to cut the rebar to size with a metal cutting hacksaw blade or another saw.